What does Home Inspection Include ?

A professional home inspection should be carried out by an experienced home inspector who has the advanced training to carry out home inspections and special equipment. Then the home inspector issues a written ” Home Inspection Report ” to the client. Our visual residential home inspection will provide a solid foundation of knowledge about the home, its components and system. In addition we will include home maintenance tips, and other information to help you protect your investment.

 

The home inspection includes all of the following and more :

STRUCTURE
Inspection of Foundations, Floors, Walls, Columns, Roofs, Garage
EXTERIOR
Our home exterior inspection includes flashing, trim, doors, windows, garage doors, decks, steps, porches, eaves, down spouts, soffits, grading, drainage, driveways, patios, walkways
ROOFING
The home inspector will examine roof coverings, drainage, flashing, chimney, signs of roof leaks
PLUMBING
The home inspector will evaluate pipes, drains, vents, faucets, water heater & venting, sumps
ELECTRICAL
Service entrance, Grounding Equipment, Distribution Panels, Light fixtures, Receptacles, Ground Fault Interrupters
HEAT and A/C
Equipment, Controls, Venting, Fans, Ducts, Safety Control
INTERIOR
Our interior home inspection covers walls, ceilings, floors, stairs, railings, doors, windows, attached garage and door
INSULATION and VENTILATION
Insulation, Venting, Kitchen & Bath Ventilation, Laundry Ventilation
SAFETY
Smoke Detectors, Carbon Monoxide Detector, Fence and Gate
AND MUCH MORE
We will even have some home maintenance tips for you.

 

 

Our Home Inspector will investigate :

• the siding, flashing and trim;
• all exterior doors, decks, stoops, steps, stairs, porches,railings, eaves, soffits and fascia;
• the vegetation, surface drainage, and retaining walls when these are likely to adversely affect the structure;
• and report as in need of repair any spacing between intermediate balusters, spindles and rails for steps,stairways, balconies and railings that permit the passage of an object greater than 4 inches in diameter;
• a representative number of windows’ condition and type;
• and describe the exterior wall covering and its condition.
• the fireplace, and open and close the damper door, if readily accessible and operable;
• the hearth extensions and permanently installed components;
• and report as in need of repair deficiencies in the lintel,hearth or material surrounding the fireplace, including the fireplace opening’s clearance from visible combustible materials.
• the roof covering’s condition and type;
• the gutters;
• the downspouts;
• the vents, flashings, skylights, chimney and other roof penetrations;
• the general structure of the roof from the readily accessible panels, doors or stairs.
• the service drop/lateral;
• the meter socket enclosures;
• the means for disconnecting the service main;
• and describe the service disconnect amperage rating, if labeled;
• the panelboards and overcurrent devices (breakers and fuses);
• the service grounding and bonding;
• a representative number of switches, lighting fixtures and receptacles, including receptacles viewed and deemed to be AFCI-protected;
• and test all GFCI receptacles and circuit breakers observed and deemed to be GFCIs;
• service entrance conductors and conductor insulation;
• service entrance cables.

He will report on:

• any unused circuit breaker panel openings that are not filled;
• the presence of solid-conductor, aluminum branch-circuit wiring, if readily visible;
• any tested receptacles in which power was not present, the polarity was incorrect, the receptacle was not grounded or secured to the wall, the cover was not in place, the GFCI devices were not properly installed or did not operate properly, and evidence of arcing or excessive heat;
• the presence of smoke detectors;
• any deficiencies in the integrity of the insulation, drip loop, or separation of conductors at weatherheads and clearances from grade or rooftops, as they may require repair.

• the heating system, using normal operating controls, and describe the energy source and heating method;
• and report as in need of repair a heating system that does not operate;
• and report if the heating system is deemed inaccessible;
• the central cooling equipment, using normal operating controls.
• determine whether the water supply is public or private;
• verify the presence of and identify the location of the main water shut-off valve;
• inspect the water heating equipment, including venting bracing, and verify the presence or absence of temperature- and pressure-relief valves and/or Watts 210 valves;
• flush toilets;
• water-test sinks, tubs and showers for functional drainage;
• inspect the interior water supply, including all fixtures and faucets;
• inspect the drain, waste and vent systems, including all shut-off valves and fixtures;
• describe any visible fuel storage systems;
• inspect drains and sump pumps and test pumps with accessible floats;
• inspect and report as in need of repair deficiencies in the water supply by viewing the functional flow in two fixtures operating simultaneously;
• inspect and report as in need of repair deficiencies in the installation and identification of hot and cold faucets;
• inspect and report as in need of repair mechanical drain stops that are missing or do not operate if installed in sinks, lavatories and tubs;
• inspect and report as in need of repair commodes that have cracks in the ceramic material, are improperly mounted on the floor, leak, or have tank components that do not operate.
• the insulation in unfinished spaces;
• the ventilation of attic spaces and the mechanical ventilation systems;
• and report on the general absence or lack of insulation in unfinished spaces.
• the foundation condition and type;
• the visible structural components;
• any wood in contact with or near soil;
• and report any present conditions or clear indications of active water penetration observed;
• and report any general indications of foundation movement that are observed, such as, but not limited to: sheetrock cracks, brick cracks, out-of-round door frames, or floor slopes;
• and report on any cutting, notching or boring of framing members that may present a structural or safety concern.
• open and close a representative number of windows and doors;
• inspect the walls, ceiling, steps, stairways and railings;
• report as in need of repair any spacing between intermediate balusters, spindles and rails for steps, stairways and railings that permit the passage of an object greater than 4 inches in diameter;
• inspect garage doors and garage door openers by operating first by remote (if available), and then by the installed automatic door control;
• report as in need of repair any installed electronic sensors that are not operable or not installed at the proper height above the garage floor;
• report as in need of repair any door locks or side ropes that have not been removed or disabled when the garage door opener is in use;
• report as in need of repair any windows that are obviously fogged or display other evidence of broken seals.

Post to Twitter Post to Delicious Post to Digg Post to Facebook

About the Home Inspector
Dan Joandrea

- I have been working in the home remodeling / construction industry for over 11 years. I have decided to open a home inspection company to help real estate home buyers to make an informed decision before making their biggest investment of their life. The home inspection is a very important step when purchasing a home.